Titanium implant abutment MAAxxxxx, SAAxxxx series

titanium implant abutment
titanium implant abutment
titanium implant abutment
Add to favorites
Compare this product


Implant diameter

Min.: 4 mm (0.16 in)

Max.: 6.5 mm (0.26 in)

Implant angulation

15 °, 25 °


Method - Use 1.2 hex driver - narrow 20Ncm joining Torque - regular/wide/ultra-wide 25~30Ncm Joining Torque Components - angled abutment + abutment scrwe - 15˚ / 25˚ composition - Various size Conventional Abutment and sylbutment The principles of The principles of SYLBUTMENT are easily discovered around us. In a conventional abutment, the gap between fixture and abutment may increase gradually due to repeated chewing forces. This is due to the contact between the outer surface of the abutment and the inner taper of the fixture, which only occurs on a small surface area due to the roughness of both the two surfaces. On the other hand, SYLBUTMENT increases the contact surfaces by transformation to the grooves. It does not create a gap as the transformation between the two surfaces occurs within the elastic range. Why does loosening occur in conventional abutments? The perfect contact of two at surfaces is only possible theoretically but practically impossible. The perfect contact of two at surfaces is only possible theoretically but practically impossible. When a chewing force is applied then removed, the gap between the two surfaces increase. As shown in the figure above, chewing forces are experienced asymmetrically - Implant connection by hex/non-hex composition is used according to surgery method and produced prosthesis Usage - conventional cement retained type abutment - Used in revising the fixture’s path - Used in cases when the prosthesis’ path needs to be adjusted


No catalogs are available for this product.

See all of UFIT IMPLANT‘s catalogs
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.