DIN outlet 37 series

medical gas

We design and manufacture our DIN 13260-2 Type Medical Gas Outlet (Terminal Unit) to ensure long life and a constant, reliable medical gas flow for patients and medical equipment.

Available medical gases include:

• oxygen (O₂)
• medical air
• nitrous oxide (N₂O)
• carbon dioxide (CO₂)
• vacuum.

All outlets are 100% tested for flow and leakage, and are cleaned for oxygen services before shipping.

These outlets are designed by industrial designers to ensure an appealing and pleasant environment for the patient and the medical staff.

DIN 13260-2 medical gas outlets can be installed in hospital wards, intensive care units, operating rooms, recovery areas, and other clinical environments. They are available in exposed, recessed, and panel-mounted configurations.

Features

• Accepts DIN 13260-2 gas-specific adapters.
• All medical gas outlets are 100% hydrostatic tested for leaks.
• The outlets are factory-assembled, degreased, and cleaned for medical gas service.
• Indexed to eliminate interchangeability of gas services.
• 360-degree swivel inlet pipe for ease of installation.
• Double position allowing parking of male adapter in the outlet.
• Low maintenance due to the use of VITON seals in the front assembly (latch valve).

Medical Gas System Standards:
NFPA 99 & EN ISO 7396-1 requirements.

Applicable Standards:
ISO 9170-1, DIN 13260-2.

Silbermann's Quality Management System:
CE marked.

Technical Data

• The medical gas outlet shall be SILBERMANN DIN type, manufactured according to ISO 9170-1 and DIN 13260-2.
• The outlet shall be gas-specific by indexing each front service panel to a gas-specific pin-indexed rough-in module.
• The outlet of positive and negative pressure shall consist of primary and secondary check valves to allow testing and online maintenance.
• The outlet shall be manufactured with 175 mm long, type K, 12.7 mm (1/2”) OD copper pipe.
• With the rough-in mounted, the outlet shall be depth-adjustable to compensate for various wall thicknesses.
• The quick-connect outlet shall comply with the ISO 9170-1 standard type and accept only the corresponding DIN 13260-2 Gas Specific Adapter.
• Pressure drop of less than 20 kPa through the outlet at 120 LPM and 350 kPa (3.5 Bar) inlet pressure.
• When fully open, the outlet allows a flow of up to 600 LPM and a pressure of 400 kPa (4 Bars).